12" Air Temp Sensor Extension Wire 99-07 Mopar 3.7,4.7,5.7,5.9

$19.99

"MADE IN THE USA"

This Extension Wire will allow you to RE-locate your Air Temperature Sensor to a cooler location WITHOUT the need to cut your harness. Like the POWER WIRE, the EXTENSION WIRE is a PLUG & PLAY mod that leaves your factory harness in-tacked. We use FACTORY STYLE plug connectors for a weather tight seal.

Details:

This Intake Air Temp Sensor Extension wire resembles our Popular POWER WIRE, and everything is the same except that the EXTENSION WIRE does NOT alter the signal to the PCM... All it does is extend your harness 12"-13". This is the fix for those who have gone with aftermarket induction systems and found the Air Temp Sensor harness will not reach your new intake. DO NOT CUT YOUR WIRES to extend your plug, just use our extension wire to add an additional 12-13" to your harness.

This wire also gives you the ability to REMOVE it at will with no trace that is was ever installed... This is help full when dealing with your service department.

The POWER WIRE will fit: All 1999-2007 3.5L, 3.7L, 4.7L, 5.7L & 5.9L engines and many other Chrysler vehicles.

  • Works with ANY/ALL stock or aftermarket induction system
  • Extend your harness 12-24" with factory connectors in your new Dodge/Jeep/Chrysler in little as 1-2 minutes of your time!

    We will only list them as we learn if they fit or not... If you purchase the Power Wire for your Magnum or Charger or ANY Dodge product and it does NOT fit send it back for a full refund.

    EXTENSION/SPLICER (EX-SPLICER) WIRE OPTION This wire is basically an extension wire modified with two exposed leads which allows you to add your own choice of resistance. You could use a resistor or even an adjustable POT resistor simply by tapping into the two exposed leads. You can use this PLUG & PLAY SPLICER wire to relocate your sensor to a cooler location or to make your own "POWER WIRE", it's cheaper to use this wire then it is to repair your factory harness. No need to CUT YOUR WIRES to extend your plug. And it allows you the freedom to pick your own resistance for a specific application. This SPLICER WIRE allows you to relocate your sensor without damaging your harness or leaving any trace of modification after removal (Great for when you take it in for service). We have many customers who have used this wire to make their own AIT mod. You can add your choice of resistor in-line to gain the desired effect. Modify the cheaper EX-SPLICER WIRE instead of cutting into your expensive harness and damaging your vehicle.

    Dropships direct from manufacturer.

    Item Photo


  • Add to Cart:

    • Model: AirRam EW0001-12 Extension Wire
    • Shipping Cost: 10.95 shipping
    • 1Dropships direct from manufacturer
    • Manufactured by: Air Ram

    Please Choose:

    Country






    This product was added to our catalog on Tuesday 01 June, 2021.

    Copyright © 2024 3rd Strike Performance. Powered by 3rd Strike Performance!