Comp Cams Beehive Valve Springs Gen 3 Hemi Chrysler-Jeep-Dodge

Valve springs are one of the most critical and overlooked components in your engine. They must be matched to your cam in order for the engine to reach its full potential. It does absolutely no good to install a cam that will perform up to 8,000 rpm if you do not have the correct springs. Use the only valve springs that will give the recommended spring pressure with the valve both on the seat and at maximum lift. COMP Cams valve springs are offered in single and dual styles to meet your cam requirements.

Valve Spring, Single, Beehive, 1.075 in./1.310 in. Outside Diameter, 372 lbs./in. Rate, 1.140 in. Coil Bind, Gen III Hemi, Set of 8

Valve Spring Style: Beehive

Number of Springs Per Valve: Single

Maximum Valve Lift (in.): 0.625 in.

Retainers Included: No

Outside Diameter of Outer Spring (in.): 1.075 in./1.310 in.

Coil Bind Height (in.): 1.140 in.

Damper Spring Included: No

Spring Rate (lbs./in.): 372 lbs./in.

Inside Diameter of Outer Spring (in.): 0.650 in./0.885 in.

Locks Included: No

Valve Stem Seals Included: No

Valve Springs Coated: No

Installed Height (in.): 1.800 in.

Seat Pressure at Installed Height (lbs.): 125 lbs.

Open Height (in.): 1.150

Open Pressure (lbs.): 367 lbs.

Remanufactured: No

Quantity: Sold as a set of 8.

Application Notes: O.D. at the top of the spring is 1.075 in. and 1.310 in. at the bottom. I.D. at the top of the spring is 0.650 in. and 0.885 in. at the bottom.

Not available for shipment outside the continental USA. We cannot ship this to Hawaii, Alaska, or other countries.

Dropships direct from manufacturer.