Comp Cams Beehive Valve Springs Gen 3 Hemi Chrysler-Jeep-Dodge

Valve springs are one of the most critical and overlooked components in your engine. They must be matched to your cam in order for the engine to reach its full potential. It does absolutely no good to install a cam that will perform up to 8,000 rpm if you do not have the correct springs. Use the only valve springs that will give the recommended spring pressure with the valve both on the seat and at maximum lift. COMP Cams valve springs are offered in single and dual styles to meet your cam requirements.

Valve Springs, 1.055 in. Outside Diameter, 313 lbs./in. Rate, 1.085 in. Coil Bind Height, Gen III Hemi, Set of 8

Valve Spring Style: Beehive

Number of Springs Per Valve: Single

Maximum Valve Lift (in.): 0.640 in.

Retainers Included: No

Outside Diameter of Outer Spring (in.): 1.290 in.

Coil Bind Height (in.): 1.140 in.

Damper Spring Included: No

Spring Rate (lbs./in.): 313 lbs./in.

Inside Diameter of Outer Spring (in.): 0.885 in.

Locks Included: No

Valve Stem Seals Included: No

Valve Springs Coated: No

Installed Height (in.): 1.800 in.

Seat Pressure at Installed Height (lbs.): 105 lbs.

Open Height (in.): 1.200

Open Pressure (lbs.): 293 lbs.

Remanufactured: No

Quantity: Sold as a set of 8.

Application Notes: O.D. at top of spring is 1.055 in. and I.D. at top is 0.650 in.

Not available for shipment outside the continental USA. We cannot ship this to Hawaii, Alaska, or other countries.

Dropships direct from manufacturer.