These are recommended for MOST 4.7L Performance builds. To be used with our ROSS Pistons. These Scat I-beam connecting rods will support over 700HP @ 7500rpms all day long. They incorporate all of the best features possible for an H-beam rod, including some strength adders found in I-beam designs. Scat Pro Comp I-beam connecting rods are profiled with clearance for long stroke applications. Good for applications up to 700+RWHP.
Scat Connecting Rod, Pro Comp, 4340, I-Beam, 12-Point, Cap Screw, 6.125 in. Length, 4.7L Magnum, Arp 8740 Chromoly Steel Rod Bolts
These Scat I-beam connecting rods incorporate all of the best features possible for an I-beam rod, including some strength adders found in H-beam designs. Scat Pro Comp I-beam connecting rods are profiled with clearance for long stroke applications. These connecting rods feature a one-rib cap design for added strength and bearing support, polished beams to eliminate stress risers, and special hollow dowels with huge 7/16 in. ARP cap screw bolts to greatly increase strength and horsepower capabilities.
Brand: SCAT Engine Components
Part Type: Connecting Rods
Product Line: Scat Pro Comp I-Beam Connecting Rods
Connecting Rod Length Center to Center (in): 6.125 in.
Connecting Rod Beam Style: I-beam
Connecting Rod Material: Forged 4340 steel
Wrist Pin Style: Floating
Pin End Bore Diameter: 0.927 in.
Rod Journal Diameter (in.): 2.000
Big End Bore Diameter (in.): 2.2250 Must be machined down to fit standard 4.7L crank mains.
Quantity: Sold as a set of 8.
Cap Retention Style: Cap screw
Big End Width (in.): 0.940 Must be machined down to fit standard 4.7L crank mains.
Clearanced for Stroker: yES
Connecting Rod Bolt Brand: ARP
Connecting Rod Bolt Diameter: 7/16 in.
Connecting Rod Bolt Material: 8740 chromoly steel
Fastener Tensile Strength (psi): 180,000 psi
Connecting Rod Bolt Head Style: 12-point
Weight Matched Set: Yes
Remanufactured: No
Magnafluxed: No
Connecting Rod Finish: Shot-peened
Notes: Custom pistons required when using connecting rods with custom wrist pin diameter and longer than stock length.
NOT INTENDED FOR USE WITH STOCK PISTONS! These rods require pistons with a .927 FREE FLOATING wrist pin. These are to be used with our ROSS Pistons only!
Use standard 4.7L TABLESS bearings with these Rods. These are the best H-Beam Rod available ready for high performance 4.7L engines.
These Rods are intended to be used with our Ross Piston sets as a combo.
These kits are intended to be BALANCED at your local machine shop, no reason to dump a ton of money into your engine only to skip balancing... this should be done on all built engines. We will do our best to send you a balance assembly but it's up to the customer to verify and balance with the crankshaft used in the buildup.
**Notes: ** Custom pistons are required when using connecting rods with any length other than OE length.
Not available for shipment outside the continental USA. We cannot ship this to Hawaii, Alaska, or other countries.
Dropships direct from manufacturer.
This product was added to our catalog on Saturday 22 February, 2025.
