LSD Doors Bolt-On Vertical Doors 05-10 Charger, Magnum, 300

$2,019.95

LSD is dead serious about product quality. If you want the absolute best of the best in lambo doors kits, LSD gets the honor hands down.

These guys are extreme in terms of the rigors they go through to ensure they have a quality product:

They had a third party perform ECE-R95 certified crash tests on the side of a car that was equipped with an LSD lambo door kit, and the third party determined that vehicles equipped with LSD doors offer the necessary protection and guarantee optimum safety for their passengers. LSD even published the crash test video so you can see it for yourself.

They also had a third party do a tensile force test in accordance with EWG guidelines and found that each hinge can withstand up to 9 newtons of force. This is one extremely strong product.

One LSD kit includes: - Pre-assembled LSD hinges with gas shock - Mounting hardware for hinges - Wire set for vehicle specific extensions of wire harnesses including mounting material - Insulated wire connectors including flexible insulation tape - TV certificate

FUNCTIONALITY: The LSD door system consists of a specific door hinge which initially opens the factory door 30 degrees outwards, like a common car door and then upwards by the support of a gas shock with minimal effort.

The door opens in 2 steps:

Step 1: Open the door outwards as usual to a maximum angle of approximately 30 degrees. Allowing comfortable access to enter and exit the vehicle.

Step 2: Lift the door after reaching the opening angle of 30 degrees. This is done with ease as the door is supported by the gas shock to an angle of approximately 40 degrees.

The LSD door hinges are installed at the original mounting points of the dismantled factory hinges. A range of adjustability is built into each LSD door hinge for perfect alignment and operation. Additional features also include limits that prevent the doors from being open too far as well as avoiding contact of the rocker panel.

Pre-installation check list: - Battery disconnected - Front bumper removal - Front fender removal - Disconnect the wire harness between chassis and door - Disassemble the door.

Mounting the ground plate to a pillar and door: - Modify the fender according to instructions (cutting the edge) - Modify the door, depending on the vehicle model (drilling an additional hole, cutting the edge) - Mount the ground plate to the mounting points of the chassis - Mount the swing arm to the mounting points of the dismantled door

Assembly and Alignment: - Mount the door to the vehicle and completely close it. Dismantling and slight modification of the fender might be necessary. The wire harness extension is necessary. For vehicles with airbags, the functionality of airbags needs to be tested after the cable is extended.

Fits: 06-10 Charger, 05-08 Magnum, 05-10 Chrysler 300

Dropships direct from manufacturer.

Item Photo


Add to Cart:

  • Model: LSD Doors 50027004 Lambo Kit
  • Shipping Cost: 49.95 shipping
  • 1Dropships direct from manufacturer
  • Manufactured by: LSD Doors


This product was added to our catalog on Sunday 11 November, 2018.

Copyright © 2024 3rd Strike Performance. Powered by 3rd Strike Performance!